Material: Stainless steel
Atomizer Material: Stainless Steel + Glass
E-liquid capacity: 2 ml
Resistance range: 0.1 – 3.5 ohm in VW/ Bypass mode; 0.05 - 1.5 ohm in TC mode
Modes: VW/ Bypass/ TC (Ni, Ti, SS, TCR-M1, M2, M3)
Coil Replaceable: Yes
Coil Rebuildable: No
Connection Threading: 510
Adjustable Wattage (WV): Yes (1-75W)
Adjustable voltage (VV): No
Adjustable temperature:100‑315'C (200'F‑600'F)
Compatible battery: 18650 (>25°)
Battery type: removable and rechargeable
Coil Compatible: Eleaf EC, EC TC-Ni orEC-TC Titanium
Atomizer protection: When vaping time exceeds 10 seconds, the device shuts down automatically.
Atomizer Low Alert: When the resistance of the coil is lower than 0.05 in TC modes, the screen will display “Atomizer Low”.
Short circuit and No Atomizer protection.
Low voltage protection.
Weak Battery Alert
Charging: The iStick Pico can be charged through USB port or by removing the batteries and by charging them separately.
Head replacement: Unscrew the atomizer base, atomizer head is located on the base, just unscrew it and screw the new head in. Drip a few drops of e liquid on the cotton before you use it for the first time and vape a few times in power-off condition (with airflow widely open) to avoid dry burn.
How to add liquid: Remove the top cap of atomizer. Then slowly refill e-liquid into the glass tube. Finally put the top cap back on the atomizer.
a) Please first drip a few drops of e-liquid directly into the pure cotton wick in the atomizer head so as to make it fully soaked before vaping.
b) Please don’t overfill and make sure the liquid level is between 10%-90%;
c) Please make sure the air-inlet holes on the atomizer base are closed before refilling e-juice.
1 × iStick Pico Body
1 x MELO III Mini Atomizer (with 1 x EC 0.3)
1 x EC 0.5ohm
4 x Silicon ring
1 × USB Cable
1 × User Manual