Compatible with: Smok Resa Prince Atomizer - Standard Edition, Smok TFV12 Prince Atomizer - Cobra Edition, Smok TFV12 Prince
Head replacement: 1) Before starting make sure your hands are clean. 2) Take the RBA deck apart. 3) Install the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base. 4) Position and cut the exceeding ends of wire off. 5) Cut a strip of cotton and make sure it's not too much and not too little. 6) Insert the cotton, and place it in the middle. 7) Cut the cotton at an angle and make sure it’s not too short and not too long. 8) Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.
1 x Smok RBA head for TFV12 Prince
Note: This product is not covered by warranty and cannot be returned.