Compatible with: Smok TFV12 RBA
Head replacement: 1) Before starting make sure your hands are clean. 2) Taking RBA-T apart. 3) Installing the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base. 4) Positioning and cutting the exceeding ends of wire off. 5) Cutting a strip of cotton and make sure it's not too much and not too less. 6) Inserting the cotton, and placing it in the middle. 7) Cutting the cotton at an angle and make sure it’s not too short and not too long. 8) Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.
1 x Smok RBA-T head for TFV12 RBA
1 X Screwdriver
1 X Sealing Ring
4 X Screw